The SD17060B is a compact and powerful 6.3 Arms stepper motor driver that boasts several enhancements over its previous iteration (SD17060). A narrower, more compact design retains the standard mounting pattern, but saves valuable panel space. Additionally, improvements to the drive yield a streamlined enclosure, eliminating the finned heat sink and permitting optional panel or side mounting for increased thermal transfer. Set-up and configuration have been simplified via onboard LED diagnostics that communicate specific fault conditions. And the Enable/Disable input can be user selected to perform either function, as well as being used to clear a fault. Standard AMCI safeguards have been carried forward, including an interlock connection to prevent injury if the motor connector is removed while the driver is powered. Additional protections include short circuit protection - phase to phase and phase to ground- and overtemperature circuitry. The SD17060B 6.3 Amp stepper motor driver will interface with AMCI's complete line of high torque stepper motors, which range in frame size from NEMA 23 to NEMA 42. These motors have been tested and selected to perfectly match the electrical requirements of the SD17060B. This combination of stepper motor driver and stepper motor provides the best performance for your application. Performance, price, and product all combine to offer you the best value.

AMCI Stepper Motor Drive, Micro-Stepping, 95 to 132 V AC, 50/60 Hz, 20 mA/30 V DC Output, 50 deg C, Panel Mount

• Direct replacement for AMCI SD17060 stepper motor drive
• Streamlined enclosure
• Frees up panel space but mounts like the standard SD17060
• Requires less cooling area and offers multiple mounting options for increased thermal transfer
• Shares standard AMCI wiring connections, facilitating installation
• User selected disable/enable input can be selected to perform either function
• Simplified set-up via onboard LED diagnostic indicates specific fault condition
• 170 VAC bus, outputs current up to 6.3 Arms, selectable in 0.1 A increments
• Automatic current reduction
• User-selectable gain for fine tuning performance
• Bipolar with two MOSFET H-bridges; average current control, 20 kHz PWM amplifier
• 2-phase
• 16 user selectable step resolutions up to 50800 and inputs are latchable and changes occur when power is cycled resolution
• Motor/load dependent maximum velocity
• 2 MHz maximum input frequency rating
• 1 to 6.3 A rms selectable with latchable dipswitches in 0.1 A increments output current
• Three latchable dipswitch selectable options 0% , 50% after 1 sec without a step pulse and 69% after 10 ms without a step pulse idle current
• Eight lead series or parallel, six lead series or center tapped or four lead motors connections
• 0 to 1 VDC, 3.5 to 27 VDC OFF state voltage and input requires 10 mA of current to operate ON state voltage
• Average current contro