EATON Digital Display Unit, LCD Display, 5 in L x 3-3/4 in W x 3-3/4 in H Dimensions

• Continuous reading of actual ground fault current, employing auto ranging
• Display of the pre-trip ground fault current, after a trip has occurred (flashing display)
• Display of the trip current setting, after a test trip has been activated
• Test and RESET pushbuttons
• The RESET button must be held pressed before the test is pressed to invoke the test procedure
• The function of this button can be enabled/disabled by inserting the interconnecting cable from the D64RPB100 relay into one of two sockets, TEST on or TEST off, on the right side of the display
• Pushing verify pushbutton shows if D64RPB100 tripped due to a ground fault prior to loss of its control voltage red trip LED lights or if there was no ground fault green run LED light strip-green run LED lights
• This indication will remain available for at least ten hours
• The numerical LCD window displays actual ground fault current in amps
• When a 5000:5 ratio interposing CT is used, all displayed values are to be interpreted as kA rather than amps
• Used with 30 ft of standard 4-wire telephone type cable connection
• Use with D64RPB100 Series B1 digital ground fault relay

• Catalog https://assets.unilogcorp.com/2/ITEM/DOC/IDW_DOCUMENT_d6740d0b161ef6e66d127a61e51449b3c365cb1ffde4fb46a640d05591b5b69f.pdf
• Specification Sheet https://assets.unilogcorp.com/2/ITEM/DOC/IDW_DOCUMENT_1ab007051541d00537f03f923449ff2101ee75e6d6d0e3b237ae4a1b10a2837f.pdf